R8#sh ip int b | e una|do
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 89.0.0.8 YES NVRAM up up
Loopback0 8.8.8.8 YES NVRAM up up
R8#sh run | s r o
router ospf 1
log-adjacency-changes
network 0.0.0.0 255.255.255.255 area 0
R9#sh ip int b | e una|do
Interface IP-Address OK? Method Status Protocol
Serial1/0 89.0.0.9 YES NVRAM up up
Loopback0 9.9.9.9 YES NVRAM up up
R9#sh run | s r o
router ospf 1
log-adjacency-changes
network 0.0.0.0 255.255.255.255 area 0
R9#sh run int s1/0
Building configuration...
Current configuration : 132 bytes
!
interface Serial1/0
ip address 89.0.0.9 255.255.255.0
encapsulation ppp
ip ospf network broadcast
serial restart-delay 0
end
R2#sh ip int b | e una|do
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 12.0.0.2 YES NVRAM up up
FastEthernet0/1 23.0.0.2 YES NVRAM up up
Loopback0 2.2.2.2 YES NVRAM up up
R2#sh run | s r e
router eigrp 100
network 0.0.0.0
no auto-summary
R2#sh ip ro e
1.0.0.0/32 is subnetted, 1 subnets
D 1.1.1.1 [90/409600] via 12.0.0.1, 00:10:30, FastEthernet0/0
3.0.0.0/32 is subnetted, 1 subnets
D 3.3.3.3 [90/409600] via 23.0.0.3, 00:10:10, FastEthernet0/1
R2#sh mpls forwarding
Tag switching is not operational.
CEF or tag switching has not been enabled.
No TFIB currently allocated.
R1#sh run | s pseudo
pseudowire-class L2TPv3
encapsulation l2tpv3
interworking ip
ip local interface Loopback0
R1#sh run int f2/1
Building configuration...
Current configuration : 124 bytes
!
interface FastEthernet2/1
no ip address
speed auto
duplex auto
no keepalive
xconnect 3.3.3.3 13 pw-class L2TPv3
end
R3#sh run | s pseudo
pseudowire-class L2TPv3
encapsulation l2tpv3
interworking ip
ip local interface Loopback0
R3#sh run int s1/1
Building configuration...
Current configuration : 122 bytes
!
interface Serial1/1
no ip address
encapsulation ppp
serial restart-delay 0
xconnect 1.1.1.1 13 pw-class L2TPv3
end
R8#sh ip ospf nei
Neighbor ID Pri State Dead Time Address Interface
9.9.9.9 1 FULL/DR 00:00:37 89.0.0.9 FastEthernet0/0
R8#sh ip ro os
9.0.0.0/32 is subnetted, 1 subnets
O 9.9.9.9 [110/11] via 89.0.0.9, 00:13:00, FastEthernet0/0
R8#ping 9.9.9.9 so lo0
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 9.9.9.9, timeout is 2 seconds:
Packet sent with a source address of 8.8.8.8
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 88/120/180 ms
R1#sh l2tp tunnel all
L2TP Tunnel Information Total tunnels 1 sessions 1
Tunnel id 1100418086 is up, remote id is 2518749472, 1 active sessions
Remotely initiated tunnel
Tunnel state is established, time since change 00:14:48
Tunnel transport is IP (115)
Remote tunnel name is R3
Internet Address 3.3.3.3, port 0
Local tunnel name is R1
Internet Address 1.1.1.1, port 0
L2TP class for tunnel is l2tp_default_class
Counters, taking last clear into account:
111 packets sent, 107 received
9008 bytes sent, 8752 received
Last clearing of counters never
Counters, ignoring last clear:
111 packets sent, 107 received
9008 bytes sent, 8752 received
Control Ns 9, Nr 13
Local RWS 1024 (default), Remote RWS 1024
Control channel Congestion Control is disabled
Tunnel PMTU checking disabled
Retransmission time 1, max 1 seconds
Unsent queuesize 0, max 0
Resend queuesize 0, max 1
Total resends 0, ZLB ACKs sent 11
Total out-of-order dropped pkts 0
Total out-of-order reorder pkts 0
Total peer authentication failures 0
Current no session pak queue check 0 of 5
Retransmit time distribution: 0 0 0 0 0 0 0 0 0
Control message authentication is disabled
R1#sh l2tun session all
L2TP Session Information Total tunnels 1 sessions 1
Session id 3278375310 is up, logical session id 65537, tunnel id 1100418086
Remote session id is 1558878854, remote tunnel id 2518749472
Remotely initiated session
Unique ID is 1
Session Layer 2 circuit, type is Ethernet, name is FastEthernet2/1
Session vcid is 13
Interworking type is IP
Circuit state is UP
Local circuit state is UP
Remote circuit state is UP
Call serial number is 1168000001
Remote tunnel name is R3
Internet address is 3.3.3.3
Local tunnel name is R1
Internet address is 1.1.1.1
IP protocol 115
Session is L2TP signaled
Session state is established, time since change 00:15:43
117 Packets sent, 113 received
9488 Bytes sent, 9232 received
Last clearing of counters never
Counters, ignoring last clear:
117 Packets sent, 113 received
9488 Bytes sent, 9232 received
Receive packets dropped:
out-of-order: 0
other: 0
total: 0
Send packets dropped:
exceeded session MTU: 0
other: 0
total: 0
DF bit off, ToS reflect disabled, ToS value 0, TTL value 255
Sending UDP checksums are disabled
Received UDP checksums are verified
No session cookie information available
FS cached header information:
encap size = 24 bytes
45000014 00000000 ff73b36f 01010101
03030303 5cea9a86
Sequencing is off
Conditional debugging is disabled
SSM switch id is 4096, SSM segment id is 8193
Final Config - http://www.4shared.com/rar/T4TwmRG7/Interworking.html
Further Readings:
http://www.cisco.com/en/US/docs/ios-xml/ios/mp_l2_vpns/configuration/15-2mt/mp-l2vpn-intrntwkg.html#GUID-E774CB40-066C-4B3F-8E1E-BEBCBED1087C
http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/fsinterw.html#wp1057606
http://blog.ine.com/2008/01/28/poor-mans-vpls/
HTH...
Deepak Arora
Evil CCIE
2 comments:
Im issuing a problem if using serial interface when using xconnect command, i got notification like this
"Interworking specified in pw-class is not supported on this interface"
but if using ethernet interface is works fine.
i had search on google, i have to change the mtu to 1500 but still not working. i had tested your gns3 file, but still not working the problem occure same as on the top.
Thanks
It might be an IOS limitation or platform you are using in GNS. I tested this with 12.2S on 7200 if I recall correctly.
Post a Comment